Thingiverse
College Bunk Bed Footstool
door Ryan_Obelisk
8
Downloads
11
Likes
0
Makes
I designed this since I was tired of having to climb up my Georgia Tech dorm bunk bed with really thin slats as makeshift ladder rungs. It hurt my feet, so I made this footstool. I tested it with Solidworks FEA with PLA and it'll be fine with a factor of safety of about 10. This should also work with other bunk beds in other universities as well; I used to go to Stony Brook University and they used the same bunk beds!
Printing:
Designed with a factor of safety of 10 (accounting for an FDM printed part as opposed to solid PLA) using generic PLA, so ABS, PETG to be perfectly fine. TPU probably with a factor of 5 though.
210 degrees C for extruder temp, and 60 degrees C for the bed temp.
No supports, print it on its largest face.
Please use 5 walls and 20% gyroid infill.
Will print in about 9-10 hours on an Ender 3.
0.4 nozzle, 0.2 layer height, but it really won't matter for these two.
Printing:
Designed with a factor of safety of 10 (accounting for an FDM printed part as opposed to solid PLA) using generic PLA, so ABS, PETG to be perfectly fine. TPU probably with a factor of 5 though.
210 degrees C for extruder temp, and 60 degrees C for the bed temp.
No supports, print it on its largest face.
Please use 5 walls and 20% gyroid infill.
Will print in about 9-10 hours on an Ender 3.
0.4 nozzle, 0.2 layer height, but it really won't matter for these two.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
