Thingiverse
ColorFabb Cardboard Spool Ring
por ReSArt
0
Descargas
0
Likes
0
Makes
I occasionally experienced feeding issues when using ColorFabb cardboard spools in my Ultimaker Material Station. Over time, the cardboard edges also generated noticeable dust and debris inside the system.
Two versions are included:
3.5 mm ring – The ring is 3.5 mm wide, resulting in a 0.5 mm side flange that rests against the cardboard spool.
4.0 mm ring – The ring is 4.0 mm wide, resulting in a 1.0 mm side flange that rests against the cardboard spool.
This is a community-designed accessory and is not affiliated with or endorsed by ColorFabb or Ultimaker. Compatibility may vary slightly depending on spool production tolerances.
If these rings help improve the reliability of your setup, feel free to post a make or leave feedback!
Two versions are included:
3.5 mm ring – The ring is 3.5 mm wide, resulting in a 0.5 mm side flange that rests against the cardboard spool.
4.0 mm ring – The ring is 4.0 mm wide, resulting in a 1.0 mm side flange that rests against the cardboard spool.
This is a community-designed accessory and is not affiliated with or endorsed by ColorFabb or Ultimaker. Compatibility may vary slightly depending on spool production tolerances.
If these rings help improve the reliability of your setup, feel free to post a make or leave feedback!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
