Thingiverse
Combcaster : A comb based upon the famous guitar.
door shubhamAT
50
Downloads
76
Likes
1
Makes
A guitar shaped comb.
Recommended Print Settings:
300 - 400 Microns. ABS is good (feels soft on head) but do note that the comb teeth will warp. I printed this extremely slow (10-15 mm/s) because of the sharp corners. It's better if it is scaled in X and Y directions to make the corners/curves bigger.
Update: Printed with PLA, results were much cleaner. I have replaced the STL with a bigger version of the comb.
I have attached the Sketchupcup file. Feel free to make this better.
Recommended Print Settings:
300 - 400 Microns. ABS is good (feels soft on head) but do note that the comb teeth will warp. I printed this extremely slow (10-15 mm/s) because of the sharp corners. It's better if it is scaled in X and Y directions to make the corners/curves bigger.
Update: Printed with PLA, results were much cleaner. I have replaced the STL with a bigger version of the comb.
I have attached the Sketchupcup file. Feel free to make this better.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!