Thingiverse
Combination Lockbox/Safe using Cryptex
von IMadeThose
18
Downloads
15
Likes
0
Makes
Combination Lockbox/safe using cryptex. Number wheels have two components to allow changing the combination.
Assembly instructions:
1) Print lid, bottom, lock body, 4 outer rings and 4 inner rings.
2) Inner rings have a rim with a gap which should be on the right side. For each of the four number wheels, push inner ring into number ring lining up gap to the desired number. If the fit is tight, tapping with a rubber mallet on a flat surface may help assembly.
3) Slide 4 number wheels onto lock body making sure numbers are not up side down. Rims should be on right of each wheel.
4) Lock is attached to lid of box with twist lock: Push lock into box lid while lining up pins with slots and twist clockwise to lock.
5) Be sure combination is entered and lid should slide onto licking bar in bottom of box.
Parts are meant to be tight so there may be initial friction. Moving parts around should help loosen. If not, sanding or trimming may be necessary.
To open: Rotate number wheels
Assembly instructions:
1) Print lid, bottom, lock body, 4 outer rings and 4 inner rings.
2) Inner rings have a rim with a gap which should be on the right side. For each of the four number wheels, push inner ring into number ring lining up gap to the desired number. If the fit is tight, tapping with a rubber mallet on a flat surface may help assembly.
3) Slide 4 number wheels onto lock body making sure numbers are not up side down. Rims should be on right of each wheel.
4) Lock is attached to lid of box with twist lock: Push lock into box lid while lining up pins with slots and twist clockwise to lock.
5) Be sure combination is entered and lid should slide onto licking bar in bottom of box.
Parts are meant to be tight so there may be initial friction. Moving parts around should help loosen. If not, sanding or trimming may be necessary.
To open: Rotate number wheels
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
