Thingiverse
combro CB-625 alignment tool
por jonnyg30
17
Descargas
9
Likes
0
Makes
simple alignment tool for the combro cb-625 chronograph.
printed in ABS
layer height : 0.2mm
infill: 15%
Ext Spd: 35mm/s
Tr Spd: 80mm/s
cooling fan: 40%
ext temp: 230C
I'm using a temp controlled enclosure (held at 45C), if you can't run the cooling fan you may need to increase all axis by a couple of % to account for contraction of the material. Using the settings above mine came out a perfect fit with no scaling required. I've not tried it in PLA but it should work.
The tool will only fit one way due to a set of grooves on one side, the grooves need to face down.
printed in ABS
layer height : 0.2mm
infill: 15%
Ext Spd: 35mm/s
Tr Spd: 80mm/s
cooling fan: 40%
ext temp: 230C
I'm using a temp controlled enclosure (held at 45C), if you can't run the cooling fan you may need to increase all axis by a couple of % to account for contraction of the material. Using the settings above mine came out a perfect fit with no scaling required. I've not tried it in PLA but it should work.
The tool will only fit one way due to a set of grooves on one side, the grooves need to face down.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
