Thingiverse
Hobby
Zum Modell
Comet 150 Micro Quad
450
Downloads
316
Likes
17
Makes
This is the Comet 150 Micro Quad Copter.
It is designed around 3" props and 1306 motors, and is intended to use common multirotor electronics and fpv gear.
Suggested setup:
Flight Controller: Naze32, CC3D, MotoLabs Tornado, etc. (30.5x30.5mm mounting)
Power Distribution Board: Matek PDB, ATAS Sphere PDB, etc.
ESCs: Little Bee 20A, DYS XM20, etc (BLHeli)
Motors: 1306 sized, 3100kv-4100kv
Battery: 450-850mAh 3S or 4S
VTX: Hawkeye or UBAD 200mW with SMA extension
FPV Cam: 28x28mm 600TVL Board Cam
Hardware: M3x8mm self tapping (for attaching Canopy), M2.2x6mm self tapping (for attaching FPV Cam to Canopy), Nylon M3 screw/nuts/standoffs (for FC/PDB stack)
It is designed around 3" props and 1306 motors, and is intended to use common multirotor electronics and fpv gear.
Suggested setup:
Flight Controller: Naze32, CC3D, MotoLabs Tornado, etc. (30.5x30.5mm mounting)
Power Distribution Board: Matek PDB, ATAS Sphere PDB, etc.
ESCs: Little Bee 20A, DYS XM20, etc (BLHeli)
Motors: 1306 sized, 3100kv-4100kv
Battery: 450-850mAh 3S or 4S
VTX: Hawkeye or UBAD 200mW with SMA extension
FPV Cam: 28x28mm 600TVL Board Cam
Hardware: M3x8mm self tapping (for attaching Canopy), M2.2x6mm self tapping (for attaching FPV Cam to Canopy), Nylon M3 screw/nuts/standoffs (for FC/PDB stack)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
