Thingiverse
Comfortable Ring 2 colors
von cashew675
41
Downloads
27
Likes
1
Makes
It is hard to find simple, fashion, but most importantly, comfortable rings to be printed by FDM. I have designed a COMFORTABLE ring using Fusion 360 in FreeForm environment. A middle layer was created by changing filament in the middle of the print.
The first thing against comfortable for some rings is the sharp edge either by the flat-bottom design or sharp decoration. Another thing is the rings cant be too thick that makes the rings fight against other fingers. To solve these problems, this ring is in ROUND shape for both the inner and outer sides and not very thick. A brim is needed and make the bottom less sharp, no support.
The ring is 10 mm in height, 19.35 mm for inner diameter that is size 9.5, 2.5 mm thick.
I find size information here https://www.thingiverse.com/thing:2161211
Scale your ring by the factor of X/19.35 where X is your ring size in mm.
I change to materials at height 2.6 and 4.4 mm and printed in 0.3 mm resolution. I do feel higher layer height make t
The first thing against comfortable for some rings is the sharp edge either by the flat-bottom design or sharp decoration. Another thing is the rings cant be too thick that makes the rings fight against other fingers. To solve these problems, this ring is in ROUND shape for both the inner and outer sides and not very thick. A brim is needed and make the bottom less sharp, no support.
The ring is 10 mm in height, 19.35 mm for inner diameter that is size 9.5, 2.5 mm thick.
I find size information here https://www.thingiverse.com/thing:2161211
Scale your ring by the factor of X/19.35 where X is your ring size in mm.
I change to materials at height 2.6 and 4.4 mm and printed in 0.3 mm resolution. I do feel higher layer height make t
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
