Thingiverse
Comica Vimo C Cold Shoe Mount
von shimazt
0
Downloads
2
Likes
0
Makes
Cold shoe mount for Comica Vimo C.
https://www.comica-audio.com/product/Vimo-C-127.html
The microphone can be attached to cold shoe.
The microphone is held in place by magnets attached to the case.
Set two magnets (6 mm diameter, 3 mm thick; be careful of their orientation) inside the back cover. Attach the back cover to the main body (no adhesive required).
Use the uploaded file to perfectly fit this mount to the cold shoe you are using.
I used Prusa Slicer to print this thing; easy to remove the support material.
https://www.comica-audio.com/product/Vimo-C-127.html
The microphone can be attached to cold shoe.
The microphone is held in place by magnets attached to the case.
Set two magnets (6 mm diameter, 3 mm thick; be careful of their orientation) inside the back cover. Attach the back cover to the main body (no adhesive required).
Use the uploaded file to perfectly fit this mount to the cold shoe you are using.
I used Prusa Slicer to print this thing; easy to remove the support material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!