Thingiverse
Commander Pro Seat
by YASAJTV
1
Downloads
6
Likes
0
Makes
Commander Pro YASAJ T-Rex SEAT
Print V2 - This will allow you to use the trolly handle as well, without holding the seat in your hands. You will need 2 x cable ties.
V3 - This is a raised/high seat for tall riders. It consists of two files. Print both and velcro or double-sided sticky tap both. The high seat gives you 3 extra inches of height making it a raised seat. (I printed the BOTTOM with 30% infill and TOP with 5%).
Enjoy this badass seat.
NOTE: If your TPU filament is soft enough then print with 20% infill, but if your TPU is hard i.e. over 95A or higher then print between 10-15% infill. Also, try variable infill by using 30% infill at the base of the model and 10% filament on the top for a softer feel.
Watch the video for more information:
https://youtu.be/pHXoxUHsOBs
Print V2 - This will allow you to use the trolly handle as well, without holding the seat in your hands. You will need 2 x cable ties.
V3 - This is a raised/high seat for tall riders. It consists of two files. Print both and velcro or double-sided sticky tap both. The high seat gives you 3 extra inches of height making it a raised seat. (I printed the BOTTOM with 30% infill and TOP with 5%).
Enjoy this badass seat.
NOTE: If your TPU filament is soft enough then print with 20% infill, but if your TPU is hard i.e. over 95A or higher then print between 10-15% infill. Also, try variable infill by using 30% infill at the base of the model and 10% filament on the top for a softer feel.
Watch the video for more information:
https://youtu.be/pHXoxUHsOBs
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!