Thingiverse
Commodore 64 Joystick
by dan188
8
Downloads
2
Likes
0
Makes
There are 2 joystick top parts:
- One for sanwa type joysticks with 45mm mounting holes.
- One for joysticks with 32mm mounting holes.
You will need 4: 3mm x 30mm screws for the joystick and small 2mm screws for the cable clamps and connector cover.
If you use a female db9 connector, you might have to file a tiny bit off the sides, as I have made the connector covers the widest they could be while still allowing 2 joysticks to fit in the c64.
The holes for the buttons are 24mm.
- One for sanwa type joysticks with 45mm mounting holes.
- One for joysticks with 32mm mounting holes.
You will need 4: 3mm x 30mm screws for the joystick and small 2mm screws for the cable clamps and connector cover.
If you use a female db9 connector, you might have to file a tiny bit off the sides, as I have made the connector covers the widest they could be while still allowing 2 joysticks to fit in the c64.
The holes for the buttons are 24mm.
dan188 also publishes on
8 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
