Thingiverse
Commodore 64 Logo
von svenpetersen1965
22
Downloads
13
Likes
0
Makes
This is the Commodore 64 logo, like it was found on the old breadbin silver labels. It is illuminated and requires some soldering, too.
It consists of three parts. The face plate is designed to the said Commodore 64 logo. The illuminated body is printed from transparent PLA with 100% infill (that is important). It is slightly smaller and will fit through the cut outs of the face plate. The illumination is accomplished with two LEDs (and of course the current limiting resistors).
The reflector can be printed with a layer heigh of 0.2mm with white PLA. It adds quite a bit of brightness and serves as a stand off for a printed circuit board (with the LEDs and resistors). An aluminum foil between the transparent part and the reflector improves the performance a bit, too.
The PCB can be found on github:
https://github.com/svenpetersen1965/Illuminated-Commmodore-logo
The fusion 360 file is included for being modified to your own needs/dimensons
It consists of three parts. The face plate is designed to the said Commodore 64 logo. The illuminated body is printed from transparent PLA with 100% infill (that is important). It is slightly smaller and will fit through the cut outs of the face plate. The illumination is accomplished with two LEDs (and of course the current limiting resistors).
The reflector can be printed with a layer heigh of 0.2mm with white PLA. It adds quite a bit of brightness and serves as a stand off for a printed circuit board (with the LEDs and resistors). An aluminum foil between the transparent part and the reflector improves the performance a bit, too.
The PCB can be found on github:
https://github.com/svenpetersen1965/Illuminated-Commmodore-logo
The fusion 360 file is included for being modified to your own needs/dimensons
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
