Thingiverse
Commodore 64 user port SD2IEC
von albank
0
Downloads
2
Likes
0
Makes
This is case for the Commodore 64 SD2IEC (user port edition) creation on PCBWay
https://www.pcbway.com/project/shareproject/SD2iEC_COMMODORE_64_DISK_DRIVE_EMULATOR_POWERED_from_USER_PORT_MICRO_SD_VERSI_c56a9f83.html
It is a pretty simple design and can be easily printed as the bottom has no overhangs that need supports and the top has minimal support for the edges required.
Three No.4 x 1/4" (2.9mm x 6.3mm) screw are needed to secure the pcb to the bottom are required.
https://www.pcbway.com/project/shareproject/SD2iEC_COMMODORE_64_DISK_DRIVE_EMULATOR_POWERED_from_USER_PORT_MICRO_SD_VERSI_c56a9f83.html
It is a pretty simple design and can be easily printed as the bottom has no overhangs that need supports and the top has minimal support for the edges required.
Three No.4 x 1/4" (2.9mm x 6.3mm) screw are needed to secure the pcb to the bottom are required.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!