Thingiverse
Commodore C64 cartridge stand
por svenpetersen1965
142
Descargas
81
Likes
1
Makes
This is printed with 15% infill and no supports. A resolution of 0.2mm is suitable.
IThe thing is used as a cartrdige stand for the Commodore C64. All standard cartridges fit, as well as the Ultimate II+.
The Commodore logo is considered to be fan art. Turned out quite nicly, when printed. There is a further version for multicolor printers. The cartridge stand itself has a logo cut out and there is a blue C and a blue and red dash.
The designs of the cartridge stand with logo were made from scratch. They are fully scalable. (The fusion 360 design). All dimensions are in the fx table.
The version with a tilt angle of 45° was constructed in a way that the label of Commodore cartridges will be visible. The length of this cartridge stand is over 20cm.
IThe thing is used as a cartrdige stand for the Commodore C64. All standard cartridges fit, as well as the Ultimate II+.
The Commodore logo is considered to be fan art. Turned out quite nicly, when printed. There is a further version for multicolor printers. The cartridge stand itself has a logo cut out and there is a blue C and a blue and red dash.
The designs of the cartridge stand with logo were made from scratch. They are fully scalable. (The fusion 360 design). All dimensions are in the fx table.
The version with a tilt angle of 45° was constructed in a way that the label of Commodore cartridges will be visible. The length of this cartridge stand is over 20cm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
