Thingiverse
Commodore Video/Serial port covers
door wikallen
12
Downloads
8
Likes
0
Makes
Snap in covers for the Video and Serial ports on Commodore Computers.
I have tested the round 64c style inside a Pixel Wizard and original 64c case. I also did test it in a C128 flat case, but its very tight. Might need some sanding or reduce the print size slightly to fit the C128 better.
The breadbin style I only tested on one style of the breadbin cases. I am not positive if it were the tall or short breadbin so your mileage may very depending on which breadbin you install this into. Again if the fit is too tight, you may try to sand the inside edge a bit or reduce the print size to get the desired tightness for you Commodore case.
I have tested the round 64c style inside a Pixel Wizard and original 64c case. I also did test it in a C128 flat case, but its very tight. Might need some sanding or reduce the print size slightly to fit the C128 better.
The breadbin style I only tested on one style of the breadbin cases. I am not positive if it were the tall or short breadbin so your mileage may very depending on which breadbin you install this into. Again if the fit is too tight, you may try to sand the inside edge a bit or reduce the print size to get the desired tightness for you Commodore case.
wikallen publiceert ook op
44 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!