Thingiverse
compact drilling guide, 2-8mm
door hudja
22
Downloads
25
Likes
0
Makes
UPDATED with 2mm hole.
90-degree drilling guide for 2, 3, 4, 5, 6, 7, 8mm drills. Compact design 25mm H, 32mm W, 77mm L. It has two side notches to help with center alignment.
There are three files for different printing tolerances: +0.1mm, +0.2mm and +0.3mm of the drill size. You can use +0.1 and drill a hole in the guide to the exact size or you can use +0.3 and the drill will be very slightly loose. It depends on your printer's precision. I suggest printing 3 walls, so that you can expand a hole in the guide to the final exact size.
Remove the circular pads around notches after printing (these are to help with the adhesion of sharp corners).
90-degree drilling guide for 2, 3, 4, 5, 6, 7, 8mm drills. Compact design 25mm H, 32mm W, 77mm L. It has two side notches to help with center alignment.
There are three files for different printing tolerances: +0.1mm, +0.2mm and +0.3mm of the drill size. You can use +0.1 and drill a hole in the guide to the exact size or you can use +0.3 and the drill will be very slightly loose. It depends on your printer's precision. I suggest printing 3 walls, so that you can expand a hole in the guide to the final exact size.
Remove the circular pads around notches after printing (these are to help with the adhesion of sharp corners).
hudja publiceert ook op
21 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
