Thingiverse
Compact Earbud Holder/Case
di rocatox
8
Download
12
Likes
0
Makes
This was intended for the Panasonic HJE-120 earbuds but probably works with others.
Can be printed with supports laying flat (stronger) or without supports standing vertical (weaker).
To use:
1. Slip the aux plug through a hole and pull so that the earbuds are in the center of the square.
2. Wind cable around the outside of the square.
3. Keeping tension, stick the aux plug into the center and through a hole so that the wound cable holds it in place.
Can be printed with supports laying flat (stronger) or without supports standing vertical (weaker).
To use:
1. Slip the aux plug through a hole and pull so that the earbuds are in the center of the square.
2. Wind cable around the outside of the square.
3. Keeping tension, stick the aux plug into the center and through a hole so that the wound cable holds it in place.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
