Thingiverse
Companion cube crosscut
door A_G_A
0
Downloads
0
Likes
0
Makes
Only simple crosscut, because the old Renkforce RF 100 3D printer does not made so much good resolution on the bottomline and crosscutted cube printing method may do it better resolution for simple devided cut.
Original:
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Original:
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
