Thingiverse
Compensated Guitar Saddle
von CalgaryToad
11
Downloads
11
Likes
0
Makes
Compensated Guitar Saddle
~80mm – ~3mm – ~14mm (top end)
This is a custom compensated guitar saddle for my dads 70’s Yamiki Guitar which has been left out far too many times and the bridge has been fixed too many to count. Bottom line is the standard 10mm height was not cutting it so I did my best to build a custom 14mm one which gives it just enough height to remain playable. Feel free to adjust the STL to your likeing
~80mm – ~3mm – ~14mm (top end)
This is a custom compensated guitar saddle for my dads 70’s Yamiki Guitar which has been left out far too many times and the bridge has been fixed too many to count. Bottom line is the standard 10mm height was not cutting it so I did my best to build a custom 14mm one which gives it just enough height to remain playable. Feel free to adjust the STL to your likeing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!