Thingiverse
Component shelf
von dzc
1
Downloads
0
Likes
0
Makes
simple component shelf for the 3d printer bits , planing to glue it on, but hole added just in case.
light use only :)
after looking at it, the holes are perhaps too low, but with superglue/hot glue it stays ok and hold the tools.
light use only :)
after looking at it, the holes are perhaps too low, but with superglue/hot glue it stays ok and hold the tools.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!