Concealed fixing hanger / hook

This is a concealed fixing wall hanger.

Simply screw the bracket to the wall using a small counter sunk screw .The base has to go the right way up - there is a recess in the square cutout on the top side.

Insert the hook into the hole angled down slightly as in the diagram, and press down until there is a click.

I Printed at 45% infill with 3 perimeters and 3 top and bottom layers in PLA.
the higher the infill the stronger it should be ,but i haven't tried it yet to see if the hook will
still fit. The tolerances are quite tight.

I've tested the hook with a heavy leather jacket and no problems, I would recommend using it for something smaller though

I will add different shape bases when I get a chance.


sorry I have to add this -

disclaimer : If you print this you do so at your own risk. if anything breaks either with the hook or bracket or anything you hang on it, I will not be held responsible.