Thingiverse
Concrete lamp
by menzenbach
92
Downloads
90
Likes
1
Makes
This is a combination of a mold for concrete and a remaining 3D printed part to hold the switch and strain-relief for the cord. The design has predetermined breaking point, which makes it easier to break to mold. Before this you should wait about 5 days for hardening.
**Important note: For the electrical work it is important to have the necessary knowledge and skills.**
There are several bulb sockets from the hardware store, which can be used. The switch has a diameter of 20mm. After installation and before molding it is helpful to glue the bulb holder into the cavity of the lamp case.
**Important note: For the electrical work it is important to have the necessary knowledge and skills.**
There are several bulb sockets from the hardware store, which can be used. The switch has a diameter of 20mm. After installation and before molding it is helpful to glue the bulb holder into the cavity of the lamp case.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!