Conducting Baton

This is a conducting baton that I made for my wife who's a conductor. It's modelled after a Mollard 12" baton. Assembly and Balance Remove the brims/supports after printing. The stick and base are friction fit. Push the base of the stick into the grip about 1cm, or until it bottoms out. The grip is slightly underweight so to balance it, magnets or ball bearings may be added into the hole if necessary. Currently the baton balances around 1cm from the rear grip. Since the baton is on the lighter side, balance shouldn't be too big of an issue depending on your grip style. In my pictures I sanded down the stick and spray painted it white. In the next revision I will work on the infill % so that the baton balances perfectly from the base of the stick. Boost MeIf you enjoyed this model, consider boosting my post!