Thingiverse
Cone Hub for SPANNERHANDS Spool System
par mmdoogie
70
Téléchargements
32
Likes
0
Makes
I loved the look of the [SPANNERHANDS Spool System](https://www.thingiverse.com/thing:2119644/) enclosed spool-holder, but wanted something with an adjustable / universal hub to fit all of the different brands of filament I am playing with. I designed and printed this to fit the large 1kg spool box and use the ubiquitous 608 bearings. The cone fits spools with a hub diameter between 24mm and 60mm. The width of spool that will fit inside the enclosure varies with hub diameter, from about 83mm with a 60mm hub down to around 47mm for a 24mm hub.
Parts needed:
* Two prints of the Cone Hub
* Two prints of the Bearing Holder
* 100 mm length of M8 threaded rod
* Two 608 bearings
* 5 M8 thin nuts
Assembly:
1. Place a drop of superglue on the outside edge of each bearing and press them into the bearing holders.
2. Place a drop of superglue on the outside edge of 4 of the nuts and press them into the four recesses in the cone hubs.
3. Thread the last nut onto the rod with enough
Parts needed:
* Two prints of the Cone Hub
* Two prints of the Bearing Holder
* 100 mm length of M8 threaded rod
* Two 608 bearings
* 5 M8 thin nuts
Assembly:
1. Place a drop of superglue on the outside edge of each bearing and press them into the bearing holders.
2. Place a drop of superglue on the outside edge of 4 of the nuts and press them into the four recesses in the cone hubs.
3. Thread the last nut onto the rod with enough
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
