Thingiverse
Cone Ice Scraper
von wankerman
45
Downloads
25
Likes
1
Makes
My own version of the Scrape-A-Round, Magic Scraper, Miracle Scraper, etc.
- Better scratching head than the real one
- Scraping profile on the exterior & interior of the cone too for double the scraping efficiency.
- Flared bottom to provide some springiness, allowing the scraper conform to the curves of the glass.
- Designed for no supports.
HANDY TIP: If you're not printing on a glossy surface, it might be a good idea to sand the bottom with up to 800 grit sandpaper for a smooth surface to get the cleanest scrape possible.
- Better scratching head than the real one
- Scraping profile on the exterior & interior of the cone too for double the scraping efficiency.
- Flared bottom to provide some springiness, allowing the scraper conform to the curves of the glass.
- Designed for no supports.
HANDY TIP: If you're not printing on a glossy surface, it might be a good idea to sand the bottom with up to 800 grit sandpaper for a smooth surface to get the cleanest scrape possible.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!