Thingiverse
Configurable Air Plug
di TheFisherOne
24
Download
16
Likes
0
Makes
This is a simple air plug for an inflatable toy. It is a measured duplicate of one used for a particular toy, but is customizable so that it should work for other toys.
The openscad source is very short and so should be a good introduction to openscad.
I re-did this project on Fusion 360 and included the source file.
The bulge is slightly different, because scaling does not work the same in Fusion 360 as it does in openscad. I also changed the length of the small section to not include the beveled part.
I tried to put all the dimensions you could edit down the right side of the sketch, and the ones that are calculated down the left side.
The openscad source is very short and so should be a good introduction to openscad.
I re-did this project on Fusion 360 and included the source file.
The bulge is slightly different, because scaling does not work the same in Fusion 360 as it does in openscad. I also changed the length of the small section to not include the beveled part.
I tried to put all the dimensions you could edit down the right side of the sketch, and the ones that are calculated down the left side.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
