Thingiverse
Configurable Spice Rack
door gjpc
1
Downloads
2
Likes
0
Makes
Our entire spice collection was single layer of jars. Looking around I could not find a solution STL so I went back to the drawing CAD. This spice rack allows you to change the shelf depth, shelf height, lip height and model thickness. Open the model in FreeCAD, call up the spread sheet and modify shelfHeight shelfDepth lipHeight and rackThickness. The cell rackWidth allows you widen the model, but be careful you are limited by your printer's Z axis for the model is printed on its right side. The side with the stabilizer, see the 3mf file.
The shelf height allows you to adjust the rack's overall height so the rack's top shelf will fit the spice jars.
No need for supports. I set the Repetier speed to 109% and got the print done in 8 hours. I had no problem with the back panel bridging on my MK3S, it came out perfect to my surprise. I used SUNLU PLA+.
After a few months in service the rack started sagging on the unsupported side. I have revised all the files to add a glue on s
The shelf height allows you to adjust the rack's overall height so the rack's top shelf will fit the spice jars.
No need for supports. I set the Repetier speed to 109% and got the print done in 8 hours. I had no problem with the back panel bridging on my MK3S, it came out perfect to my surprise. I used SUNLU PLA+.
After a few months in service the rack started sagging on the unsupported side. I have revised all the files to add a glue on s
gjpc publiceert ook op
52 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
