Thingiverse
Tools
Zum Modell
Connecting Rod Bottle opener split pattern for sand casting
223
Downloads
226
Likes
2
Makes
I made this sand cast connecting rod bottle opener.
This part is a split pattern for sand casting, it has a minimum of 5 degrees of draft on all surfaces to aid removal from sand molds. It should be printed in duplicate, and assembled with 2.5x6mm pins in the far holes.
I have reduced the gap between the opening blades to 15mm to improve function. the pictured pattern and castings have a 20mm gap, which is too wide and can grip the glass lip of the bottle.
This part is a split pattern for sand casting, it has a minimum of 5 degrees of draft on all surfaces to aid removal from sand molds. It should be printed in duplicate, and assembled with 2.5x6mm pins in the far holes.
I have reduced the gap between the opening blades to 15mm to improve function. the pictured pattern and castings have a 20mm gap, which is too wide and can grip the glass lip of the bottle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
