Thingiverse
Conscendo Evolution table stand
por alpo16000
1
Descargas
2
Likes
0
Makes
Conscendo Evolution table stand
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
PLA / 0.2 / no support needed
I used 2 PVC plumbing tubes:
length 50cm / diameter 32mm
The passage holes for the PVC tubes are through. So, test the length of the tubes that suits you best before cutting them permanently.
After that, the holes are masked by the caps
alpo16000 también publica en
24 modelos adicionales en 3 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
