Constant Current Device

This is meant to work in conjunction with the DIY power Supply i designed also, this has a 50mmx50mmx10mm fan (usually found in 3d printer hotend cooling systems) its a 12V fan (with molex adapter) that will work with the already separated lines from the 24 pin atx computer harness i made. this has not been fully tested and would advise great caution when using the constant current device in this enclosure, though it does have active cooling I am not sure on both the thermal output of the device and im not sure the thermal dispassion with the fan. Thus i have limited the CC device to 45V out of the 60V max giving it about 75% max utilization. This works with WEGE WZ6012 power supply front panel also.

I created a 3mf file for the top as there was need for supports but only the painted kind.

I USED TONS OF HOT GLUE ON THIS ALSO!!! for insulation on the bottom and for making sure the device stays in the bottom half.



After doing this i was able to fully output the 45V and 12A,