Thingiverse
Control Board - Creality + Mosfet
von Apeire
50
Downloads
40
Likes
1
Makes
Hi everybody,
This is a control panel used in my Ender 5 for my V1.1.5 and Mosfets.
Basically, there are 3 modules:
1) The display module, for the original 12864.
2) The electrical part, for the V1.1.5 and Mosfets.
3) The 80mm fan holder.
Then there are 2 prints more:
4) The fan protector in honeycomb shape.
5) The lid.
The first 3 modules are assembled together with 4 M3 screws, 8mm long recommended. Sorry, I am not a professional designer and there are some points to improve. You may get a 5mm screw and get a bit short (but functional), or 10mm and be a little bit long, which wouldn't matter in terms of practicality.
The lid is easy to mount and it has been design to have a couple of 6x3 magnets. One the one that holds the box closed, and other one in the joint in the fan module.
The mosfet board holders are for 50x60mm mosfet boards. I would recommend placing them with the cables looking to the display.
BOM used:
M3 screws between 5mm and 10mm.
Mosf
This is a control panel used in my Ender 5 for my V1.1.5 and Mosfets.
Basically, there are 3 modules:
1) The display module, for the original 12864.
2) The electrical part, for the V1.1.5 and Mosfets.
3) The 80mm fan holder.
Then there are 2 prints more:
4) The fan protector in honeycomb shape.
5) The lid.
The first 3 modules are assembled together with 4 M3 screws, 8mm long recommended. Sorry, I am not a professional designer and there are some points to improve. You may get a 5mm screw and get a bit short (but functional), or 10mm and be a little bit long, which wouldn't matter in terms of practicality.
The lid is easy to mount and it has been design to have a couple of 6x3 magnets. One the one that holds the box closed, and other one in the joint in the fan module.
The mosfet board holders are for 50x60mm mosfet boards. I would recommend placing them with the cables looking to the display.
BOM used:
M3 screws between 5mm and 10mm.
Mosf
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!