Control Panel for Air Conception Nitro Paramotor

This is a part I made for my Air Conception Nitro 200 e-start Paramotor. I started by wanting to move the ignition switch to a place where I could turn it on after the motor was on my back and evolved into an hour meter, battery monitor, status LED and a place to put the switch to my strobe light.

Designed to be held to the frame with four zip ties, there's also a cutout for the netting tension cord. If you disassemble your machine a lot, you may have to unzip the panel to get your cord through when removing the net.

Update: Panel1 updated to include correct cutout for Skyflar nut.

01/11/18 Update: Included panel for just the Switch and LED

02/28/19 Update: The opening for the net tether / spring was increased so that you do not have to remove the panel to remove your net completely. Also included panel 1 design without the strobe button hole and a switch only panel.

The cutouts are very specific to certain components, they are:

(You may need to copy/paste the Ama