Controlled COB LED MOD Upgrade

✨ Features 💡 LED strip integrated into the printer 🎛️ Control directly via the Kobra S1 display / slicer 🔌 No additional controller needed 🧼 Clean and minimal wiring ⚡ Uses existing power from the printer 🧰 Required Parts Any 24V LED strip (I have used this 4mm version) SS8550 PNP transistor 1 kΩ resistor Wires 📸 Included Before / after images Wiring instructions (what to solder) Circuit diagram 🔧 Installation This mod requires basic soldering skills. You will need to: Solder a connection to the control signal (from the LED output) Connect the LED strip to ground and Follow the provided wiring diagram ⚠️ Make sure to double-check polarity and connections before powering on. ⚠️ Disclaimer Perform this mod at your own risk Basic electronics knowledge is recommended 💡 Notes Works with standard 24 V LED strips (check voltage compatibility) Clean cable management is recommended for best results