Thingiverse
Controller Box cooling platform
von Blanz
3
Downloads
0
Likes
0
Makes
This is my rendition of a external cooling platform for the Creality CR-10 controller box.
The bottom plate is removed from the printers controller box and the existing fan connected to the bottom plate is disconnected and the new 92mm fan is then hooked up to those power leads.
I've designed this around a 92mm x 32mm cooling fan. A 25mm fan will also work in this application.
It is designed as two piece so as to fit on a 300mm x 300mm bed.
The bottom plate is removed from the printers controller box and the existing fan connected to the bottom plate is disconnected and the new 92mm fan is then hooked up to those power leads.
I've designed this around a 92mm x 32mm cooling fan. A 25mm fan will also work in this application.
It is designed as two piece so as to fit on a 300mm x 300mm bed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!