Cooler Master Master Hub Adjustable Kickstand

This is for the new upcoming CoolerMaster product. Users who have received the unit may have issues using it without an included kickstand as the included rubber bumper does not raise the unit to a useable height. This is a fully modular kickstand concept that uses fully printed parts so you can be up and running in about an hour. Assembly time is at most 5 minutes. If you want to lay the unit flat the whole thing packs away into a flat single piece! Try PETG if your PLA is not rigid enough. BambuLab PLA prints fine as does Polymaker PLA. Assembly instructions:Insert Angled Legs over cylinder closest to the main ring. Use small square posts to lock in place.Insert Toothed Legs over rear cylinder closest to the end of the platform. Use tall square posts to lock in place.Pack unit flat and lay MasterHub on flat surface.Remove Center rubber gasket from rear of unit to expose screw. Remove with T5 driver and set safely aside.Carefully slide screw platform through hole in top center of bump