Slicer Discord
Cooler Master NR200 cable management bracket – Modèle 3D imprimable de MakerWorld MakerWorld
Electronics

Cooler Master NR200 cable management bracket

16 Téléchargements
13 Likes
11 Makes
Voir le modèle
Cable management bracket / aid for use with cooler master NR200 / NR200P cases The bracket utilises the mounting points / holes for 2.5inch hard drives. It is a two-piece design to allow easier printing and installation To install, remove the rubber grommets occupying the holes firstInsert half a piece at a time, you should hear a click which confirms seatingInsert the other half, press firmly until you hear the click again To remove, pinch the tip from the other side of the panel to release the bracket
Catégorie
Electronics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Polycarbonate
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection