Cooler Tie Down

You screw these four feet into your boat dock or floating platform, with half inch of wiggle room for slightly different coolers, and your cooler will rest here, and you use bungee cords or wire to keep the cooler down tight. Screw down into two or three of the screw holes. Where the bungee cord connects, you can break free the tiny bit of support plastic. Made with love but very quickly, so let me know of any changes to make. When printing, this should be about five inches by five inches, but it doesn't really matter, and you can scale the height how you wish. Keep in mind, most PLA plastic melts in the sun! High-temp PLA is fine, but spray it with a UV spray anyway. Or flex seal over it, to keep away the harmful sun UV rays, or plastic gets brittle in a few years. Made by royce edward barber of www.ontu.org or "Royce Edward Barber" on Facebook.
Designed in sketchup, here is the url;
https://3dwarehouse.sketchup.com/model/d73a22db-070f-4fd7-b000-343661c2ad3b/Cooler-Tie-Down