Thingiverse
corkboard hanger
von pedrocorreia9824
1
Downloads
0
Likes
0
Makes
This was made for a corkboard with a wooden frame.
The small flat surface should be in contact with the wall with the wedge facing upwards allowing the wedge to lock between the frame and the board.
Use 1 to 2 mm diameter nails.
should be printed with the big flat surface as base.
The small flat surface should be in contact with the wall with the wedge facing upwards allowing the wedge to lock between the frame and the board.
Use 1 to 2 mm diameter nails.
should be printed with the big flat surface as base.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
