Thingiverse
Corkholder Ender 3 Hotbed
by xXWSDCXx
3
Downloads
2
Likes
0
Makes
Cut a corkplate in size of your Ender3-Hotbed.
In the center of the corkplate should be a hole (6x6cm) to give the screws in your Y-axis a bit more space.
Cut holes (5mm) on the corners of an centered 17x17cm square.
Mount the corkplate under your hotbed with my holder. Use the standard levelingscrews and 4 washers.
No Glue needed.
In the center of the corkplate should be a hole (6x6cm) to give the screws in your Y-axis a bit more space.
Cut holes (5mm) on the corners of an centered 17x17cm square.
Mount the corkplate under your hotbed with my holder. Use the standard levelingscrews and 4 washers.
No Glue needed.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!