Slicer Discord
Corne 4.1 Angled Bottomplate – Modèle 3D imprimable de MakerWorld MakerWorld
Electronics

Corne 4.1 Angled Bottomplate

21 Téléchargements
4 Likes
8 Makes
Voir le modèle
Angled corne 4.1 bottom plate.Angle is about 3 degrees.Recessed areas for silicone feet (8mm).Screws for board mounts are inset to allow for the same m2 screws that are part of the build guide on github.Print is shown above with the silicone feet because I assembled before taking photos. I included a render though to show the recesses for the feet. Printed at extra fine or 0.08mm layer height to minimize angle steps on final print. I meant to print on the smooth plate, but forgot to swap it out. I would recommend the smooth plate over the textured plate to ensure that the standoffs are mounted flush. In my print, this ended up not being a problem.
Catégorie
Electronics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
couches de 0.08mm · post-traitement important
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 2/3
Taille du plateau 0/3
Post-traitement 2/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Hauteur de couche
0.08 mm
Post-traitement
Ponçage, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection