Corne Keyboard Fitted case

Found a lot of casing for the Corne on thingiverse but I did not like the loosiness around the pcb, so I went around and designed a tight one.
Top plate is 1.6mm

with spacers! ready to mount with m2 screws !

Tested with:
Cherry V3 with symetric pcb, fit perfectly
Classic PCB also work but I had to sandpaper a little the pcb as it was TOO tight ;)

UPDATE: there is 2 pairs of files available:
One is builded for 4mm holes in PCB: careful, the M2 screw might break it
One is builded for 5mm holes in PCB: better resistance against M2 torque