Slicer Discord
Corne Wireless (typeractive) – 3D-Druckmodell von MakerWorld MakerWorld
Office

Corne Wireless (typeractive)

34 Downloads
9 Likes
13 Makes
Zum Modell
The case is for a wireless corne board found here. If you are looking for the Choc version of this case it will be uploaded soonIt was modified from the Corne HiPro Case by mburrowsThe way I modified the case was :Specific holes cut for the switch and reset buttonExtended switch and reset buttonsRecessed holes to fit the head of an M2 boltRemoved the overhang above the usb as it was interfering with some usb cablesMoved the cutout up a bit to cover more of the battery and look cleanerI still have some plans moving forward with this case, I will most likely either be updating it or making a v2 including some way of covering the nice nano or integrating a nice view into it.I print the case out of PLA solid by increasing the bottom layers in my slicer to the number of layers the case is at .2 mm 90 layers. Once you have printed the case, button, and switch you can install them. Make sure the flat side of the button is facing down, as it came off of the bed. Then add either M2 bolts, stand
Kategorie
Office
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

orangeflow veröffentlicht auch auf

4 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen