Thingiverse
Corner acrylic Mounts
par jamesfl
6
Téléchargements
6
Likes
0
Makes
2/4/19
These are too thin. The bottom of the hole for the magnet is too close to the edge. I think it's only one layer thick. I also found it to not be a true triangle.
2/3/19
These are to be used with the 10mm diameter 1.75mm thick magnets. I am going to glue them to each corner of the acrylic sheet instead of using hinges.
I haven't printed these yet. I would think minimal infill 10% maybe. Will test and update.
Updates to come
These are too thin. The bottom of the hole for the magnet is too close to the edge. I think it's only one layer thick. I also found it to not be a true triangle.
2/3/19
These are to be used with the 10mm diameter 1.75mm thick magnets. I am going to glue them to each corner of the acrylic sheet instead of using hinges.
I haven't printed these yet. I would think minimal infill 10% maybe. Will test and update.
Updates to come
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
