Thingiverse
Corner Bracket 100mm
door krikey
63
Downloads
60
Likes
0
Makes
A 100mm on its side corner bracket. It's not going to change the world, or win any fancy awards for ingenuity.
I wouldn't trust it to hold the weight of your prized antique 3000 piece bone china set, but good enough for some simple stuff or even trueing up.
Its lightweight, quite strong due to the 45 degree section so doesnn't deform as easily and has multiple mounting holes on each side, just in case you happen to forget that there was already a screw behind it getting in the way.
I didn't add these additional holes because of this, honest!
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
I wouldn't trust it to hold the weight of your prized antique 3000 piece bone china set, but good enough for some simple stuff or even trueing up.
Its lightweight, quite strong due to the 45 degree section so doesnn't deform as easily and has multiple mounting holes on each side, just in case you happen to forget that there was already a screw behind it getting in the way.
I didn't add these additional holes because of this, honest!
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
