Slicer Discord
Corner Clamp Braced – Modèle 3D imprimable de Thingiverse Thingiverse
Corner Clamp Braced – Bild 1 Corner Clamp Braced – Bild 2 Corner Clamp Braced – Bild 3 Corner Clamp Braced – Bild 4 Corner Clamp Braced – Bild 5 Corner Clamp Braced – Bild 6
Tools

Corner Clamp Braced

par nexustar · Tools
351 Téléchargements
229 Likes
1 Makes
Voir le modèle
Remixed from Bastien's Coner Clamp, addressing some comments people made on that design before I printed these myself regarding tolerance and strength. Focusing on the 109mm extended clamp, I added some braces and extended channels to provide less chance of any flexing over glue-up time. Take a look at Bastien's original as it includes some other options. This set is a subset of that set, with a remixed 109mm extended clamp in with two choices:

Base_longer_109mm Braced - A strengthened version of Bastien's clamp, original tolerances.
Base_longer_109mm Braced and Tight - As above, but requires a rubber mallet to get them together, however, they are nice and tight (the male connector's fit-tolerance was reduced slightly)

Parts needed:
---------
M8 bolt rod about 120 mm long (5/16 inch, 4,5 inch long) 2x
M8 hex nut's (5/16 inch) 6x

Printed parts:
---------
Base_longer_109mm_Braced_* 2x
Slider_V4 2x
Knob_V4 2x
Endcap_V4 1x

Single Endcap_V4 does NOT need to printed. It'
Catégorie
Tools
Source
Thingiverse
Publié
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Pourquoi ?
post-traitement important
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 2/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Post-traitement
Collage, Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection