Thingiverse
Corner clamp
door SAIF_33170
34
Downloads
31
Likes
0
Makes
This tool is designed for joining corners of wood or ply.
**PREPARING THE CLAMP_**
Just insert the threaded rod through the hole of the clamp body and attach the knob (to attach it put pressure against the head of rod until you hear any clicks).
**USE_**
Place one side of the square platform on the corner of your board, then line-up the notch of the clamp with the straight guide on the wall of square platform and push it down. After that lock it down. Again follow the same procedure for the other side.
[Actually anybody can do it without this instructions but something is better than nothing ;) ]
**Make sure 100% infill to make it stronger!**
The G clamps are modified from here_
https://www.thingiverse.com/thing:1673030
**PREPARING THE CLAMP_**
Just insert the threaded rod through the hole of the clamp body and attach the knob (to attach it put pressure against the head of rod until you hear any clicks).
**USE_**
Place one side of the square platform on the corner of your board, then line-up the notch of the clamp with the straight guide on the wall of square platform and push it down. After that lock it down. Again follow the same procedure for the other side.
[Actually anybody can do it without this instructions but something is better than nothing ;) ]
**Make sure 100% infill to make it stronger!**
The G clamps are modified from here_
https://www.thingiverse.com/thing:1673030
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!