Slicer Discord
CornerCaddy – Modèle 3D imprimable de MakerWorld MakerWorld
Gadgets

CornerCaddy

par iksalama · Gadgets
0 Téléchargements
0 Likes
0 Makes
Voir le modèle
This is a CornerCaddy. You need 4 of them to complete a table/bench. It is designed so that you place a 1.5" PVC pipe in the bottom (elongated hole) and a ¾" thick sheet of plywood in the slot. These CornerCaddy's will go on each corner of the wood sheet and create a table/bench. You will notice that the top is open as well, this is so you can insert another PVC pipe on the top side and create a shelving unit should you choose. I recommend a minimum of 5 walls and 5 top and bottom layers along with 35% infill - I use Support Cubic for mine. Designed for using PETG, though I suspect PLA/ABS/ASA/etc.. will work just fine. My calculations say it should hold 200lbs if using a 2 foot by 4 foot MDF/Plywood top. Be sure to support your PVC by adding braces for stability (t-fittings and cross pipes should suffice).As with anything, you do this at your own risk. I've tested it for MY application and found it acceptable. You should absolutely test and proceed with caution.
Catégorie
Gadgets
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA, ABS, PETG
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection