Cornhole Scoreboard

I have been working on this for a little while and I think it is ready to be released. I would like to try it out first here in hopes for feedback from all the maker world users! My intension was for this to be a cornhole scoreboard (but can be used for any game that goes up to 21 points) that mounts to the back of the board via the two holes on each side of the scoreboard but could also be mounted vertically somewhere else. The sliders each have a magnet in them along with a magnet on each side of the board. Inside the board has a small detent at each center of a number which makes a satisfying click when sliding to the number. I printed this out of ASA for the UV and heat resistance for longevity. I used 5mmx2mm magnets inside the board and the sliders. The sliders ride on a rail on the backside of the boards for more security when sliding. 5mmx2mm Magnets used: https://www.amazon.com/dp/B078BGGYH8?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1 NOTE: be sure to watch the orientation of the m