Thingiverse
Cornhole Wall Mount
von slammhog
70
Downloads
53
Likes
0
Makes
***Mount your cornhole boards on the wall!***
This is only my second design with Tinkercad, so please don't be too harsh. Be sure to note the infill at 70% with a Cubic infill pattern for a strong print.
-50mm in height, 140mm in length, and 50mm in depth
-Holes are countersunk
-Large hole is 10mm diameter
-Small hole is 4mm diameter
-Large lag bolt recommended to bear most of the weight
-Small construction screw used for extra stability
This is only my second design with Tinkercad, so please don't be too harsh. Be sure to note the infill at 70% with a Cubic infill pattern for a strong print.
-50mm in height, 140mm in length, and 50mm in depth
-Holes are countersunk
-Large hole is 10mm diameter
-Small hole is 4mm diameter
-Large lag bolt recommended to bear most of the weight
-Small construction screw used for extra stability
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!