Corona Hook Holster

Printed the Savegrabber Remix V2, and the holder that came with it. The holder broke almost the first day using it. So I redesigned a heavier holder. The back clip needs a little more tweaking as it is a bit thin.

This holder also has a closed bottom design, with the original I found that I would sometimes accidentally touch the dirty part of the hook.

Printed in PETG at 0.5 mm nozzle (but should work with 0.4 fine), supports.

With .5 nozzle found the supports are harder to remove.

Note on the hook: I printed a few of them and the best is ABS with acetone smoothing, seals up all the pores, and makes it easy to disinfect with alcohol.

Added version 2 with thicker clip. Have not test printed yet.