Thingiverse
Coronavirus RNA Sequence
par nieswand
2
Téléchargements
2
Likes
0
Makes
The full [RNA sequence of the Coronavirus](https://www.ncbi.nlm.nih.gov/nuccore/MN908947.3) as visualized by Reddit user [u/dx8xb](https://www.reddit.com/user/dx8xb) and shown [in his post in r/dataisbeautiful](https://www.reddit.com/r/dataisbeautiful/comments/fkwova/oc_rna_sequence_of_covid19_this_8kb_of_data_is/).
I split dx8xb's image by color and created separate STLs so I could print it in multiple colors on my single extruder Ender 5.
You can either start with the base.stl and then print the colors on top or - as I did - flip everything upside down and start with the colors.
If you use a BLTouch for ABL make sure that you only use it before the first print and use the saved measurements for the following parts. In Cura you can find this under Extensions -> Post Processing -> Modify G-code -> Use Previous Probe Measurements.
Also: make sure to use a skirt only on the first part and clean up any priming lines before starting the next part.
Some little parts didn't stick
I split dx8xb's image by color and created separate STLs so I could print it in multiple colors on my single extruder Ender 5.
You can either start with the base.stl and then print the colors on top or - as I did - flip everything upside down and start with the colors.
If you use a BLTouch for ABL make sure that you only use it before the first print and use the saved measurements for the following parts. In Cura you can find this under Extensions -> Post Processing -> Modify G-code -> Use Previous Probe Measurements.
Also: make sure to use a skirt only on the first part and clean up any priming lines before starting the next part.
Some little parts didn't stick
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
